Waste Toner Cable Removal - Lexmark X792 Service Manual

Waste toner cable removal

See "Waste toner cable" on page 7-69
1.
Remove the waste toner sensor cover. See
2.
Remove the waste toner left cover. See
3.
Remove the lower frame cable cover. See
4.
Remove the LVPS. See
5.
Disconnect the cable connector from the system board at JWTB1.
Note: The waste toner cable splits to connect to three beacons and two sensors on the front of the printer.
You disconnected the cable from one beacon when you removed the waste toner left cover.
6.
From the channel under the lower frame cable cover, disconnect one end of the cable from the standard
tray beacon cable.
for the part number.
"Waste toner sensor cover removal" on page
"Waste toner left cover removal" on page
"Lower frame cable cover removal" on page
"Low-voltage power supply (LVPS) removal" on page
7562
4-32.
4-31.
4-20.
4-81.
4-165
Repair information
Previous
Next
Go Back