Lexmark X792 Service Manual page 514

7562
4.
Disconnect the cable and ground (C) from the scanner interface card.
5.
Lift the ADF unit assembly, and remove the two front thumb screws (D).
6.
Slide the ADF unit assembly back, and lift to remove it.
Installation note: After replacing the ADF unit assembly, you must calibrate the scanner and check for skew.
See "Calibrating the scanner" on page
adjustment" on page
4-204
Service Manual
3-67, "Adjusting skew" on page 3-54
3-66.
and "ADF magnification
Previous
Next
Go Back