Lexmark X792 Service Manual page 103

Error code Action
54 Serial option <x>
error
54 Std Network
Software Error
55 Unsupported Option
in Slot <x>
If this does not fix the problem, replace the system board. See
page
56 Standard Parallel
Port Disabled
56 Parallel Port <x>
Disabled
56 Serial Port <x>
Disabled
56 Standard USB Port
Disabled
57 Configuration Configuration changes may be:
Change
Held Jobs May Not
Be Restored
See Configuration
Change, above - not in
IR as 57
58 Too Many Flash Too many flash options are installed. To continue:
Options
If this does not fix the problem, replace the system board. See
page
• Make sure the serial link is set up correctly and the appropriate cable is in use.
• Make sure the serial interface parameters (protocol, baud, parity, and data bits) are set
correctly on the printer and host computer.
• Select Continue to clear the message and continue printing.
The job may not print correctly.
• POR the printer. If this does not fix the problem, replace the PCI card.
• Select Continue to clear the message and continue printing. The job may not print
correctly.
• Program new firmware for the network interface.
• POR the printer. If this does not fix the problem, replace the PCI card.
1. Turn the printer off.
2. Unplug the power cord from the wall outlet.
3. Remove the unsupported option.
4. Connect the power cord to a properly grounded outlet.
5. Turn the printer on.
4-149.
• Select Continue to clear the message. The printer discards any data received through
the parallel port.
• Make sure the Parallel Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the PCI card.
• Select Continue to clear the message. The printer discards any data received through
the parallel port.
• Make sure the Parallel Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the PCI card.
• Select Continue to clear the message. The printer discards any data received through
the serial port.
• Make sure the Serial Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the PCI card.
• Select Continue to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the system board. See
on page 4-149.
• Code version changes
• Paper handling options removed
• The disk was installed from a different model or speed of printer.
1. Turn off and unplug the printer.
2. Remove the excess flash memory.
3. Plug in the printer, and turn it on.
4-149.
7562
"System board removal" on
"System board removal"
"System board removal" on
2-63
Diagnostic information
Previous
Next
Go Back