Adf Separator Torque Limiter Assembly Removal - Lexmark X792 Service Manual

3.
Lift the tab (A), and slide the separator roll off the shaft.
Installation note: After sliding the separator roll onto the shaft, twist it until it fits into the grooves on to the torque
limiter.

ADF separator torque limiter assembly removal

See "ADF feed and drive" on page 7-25
1.
Remove the ADF separator roll. See
2.
Slide the ADF separator torque limiter assembly off the shaft.
A
for the part number.
"ADF separator roll removal" on page
7562
4-194.
4-195
Repair information
Previous
Next
Go Back