Lexmark X792 Service Manual page 121

Step Questions / actions
6 Open the left access door, remove the two
screws (A), and pull out the fuser autoconnect
enough to check the cable for proper
connection.
Is the cable properly connected?
7 Check the cable for damage.
Is the cable damaged?
Yes
Go to step 7.
Replace the Fuser and
system card LVPS cable.
See "Fuser system card
and LVPS cable removal"
on page 4-63.
7562
No
Reseat the cable.
Replace the system board.
See "System board
removal" on page 4-149.
2-81
Diagnostic information
Previous
Next
Go Back