Staging Paper Path Reference Edge Adjustment; Aligning The Staging Paper Path Reference Edge - Lexmark X792 Service Manual

Staging paper path reference edge adjustment

After installing a new staging paper path reference edge assembly, use the following instructions to make sure it
is properly aligned.

Aligning the staging paper path reference edge

1.
Verify that the paper is square. Go to
2.
Properly adjust the tray guides in Tray 1 for the media being used, and place at least 100 sheets in the
tray.
3.
Power on the printer, and make Tray 1 as the defualt tray. Do any of the following:
•
From the control panel, select the Default Source from the Paper Menu.
•
For Windows users, select the paper source from Print Properties.
•
For Macintosh users, select the paper source from the Print dialog and pop-up menus.
4.
POR the printer, and enter Diagnostics mode: press and hold 3 and 6, turn on the printer, and release the
buttons when the splash screen appears.
5.
From the Diagnostics menu, navigate to:
REGISTRATION > Quick Test
An alignment page prints. Print three to four pages.
Note: If you cannot see both the right and left alignment marks on the top of the test page, go to
the top margin" on page
"Making sure the paper is square" on page
3-70, and adjust the top margin until the marks are visible.
7562
Previous
3-54.
Go Back
"Aligning
3-69
Diagnostic aids
Next