Groomer Reel And Groomer Plate Assembly - Toro Reelmaster 5010- H Service Manual

Groomer Reel and Groomer Plate Assembly

20
17
11
13
6
7
Antiseize
Lubricant
RIGHT
FRONT
1. Groomer reel
2. Pulley spacer
3. Washer (for pulley alignment)
4. Driven pulley
5. Flange nut
6. Excluder seal (2 used)
7. O- ring
8. Idler plate
NOTE: The groomer reel drive is located on the oppo-
site side of the cutting unit from the cutting reel motor.
Figure 8 shows components used when the groomer
reel drive is on the left side of the cutting unit.
Removal (Fig. 8)
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove cutting unit from machine.
NOTE: If cutting unit is equipped with powered rear roll-
er brush, removal of roller brush components will be
necessary to service groomer plate assemblies (see
Rear Roller Brush (Optional) in the Service and Repairs
section of Chapter 7 - Cutting Units).
Groomer
23
24
18
19
1
Antiseize
Lubricant
Loctite #242
85 to 95 ft- lb
(115 to 128 N- m)
9. Extension spring
10. Retaining ring
11. Socket head screw (2 used per hub)
12. Pivot hub (drive side)
13. O- ring (1 used per hub)
14. Groomer plate (drive side)
15. Groomer shim
16. Groomer drive shaft
Loctite #242
85 to 95 ft- lb
(115 to 128 N- m)
Loctite #242
14
6
2
3
27 to 33 ft- lb
(37 to 44 N- m)
Figure 8
2. To remove groomer plate (item 14) from groomer
drive side of cutting unit:
A. Remove groomer belt cover, groomer drive belt,
drive pulley and driven pulley from cutting unit (see
Groomer Assembly in this section).
B. Slide washer(s) (item 3) and pulley spacer (item
2) from groomer shaft.
C. Remove shoulder bolt (item 20) that secures
quick- up ball joint rod to drive side groomer plate.
Locate and retrieve spacer from between ball joint
rod and groomer plate.
D. Disconnect idler extension spring (item 9) from
stud on groomer plate.
Page 8 - 10
7" CUTTING UNIT SHOWN
Antiseize
Lubricant
17 to 21 ft- lb
(23 to 28 N- m)
15
21
Antiseize
Lubricant
22
20
4
5
13
8
16
17. Pivot hub (non- drive side)
18. Groomer plate (non- drive side)
19. Reel threaded insert
20. Shoulder bolt
21. LH ball joint rod
22. Spacer
23. RH ball joint rod
24. Spacer
Reelmaster 5010- H
12
11
9
10