Toro Reelmaster 5010- H Service Manual page 25

Removal (Fig. 4)
CAUTION
The muffler and exhaust pipe may be hot. To
avoid possible burns, allow the engine and ex-
haust system to cool before working on the ex-
haust system.
1. Raise and support hood to gain access to exhaust
system. Allow engine and exhaust system to cool before
doing any disassembly of exhaust system components.
2. Remove exhaust system components from the en-
gine as necessary using Figure 4 as a guide. Discard ex-
haust gasket (item 13) if exhaust header (item 11) was
removed.
Installation (Fig. 4)
IMPORTANT: If exhaust studs were removed from
engine cylinder head, thoroughly clean threads in
head and apply Loctite #277 (or equivalent) to stud
threads before installing studs into head.
NOTE: Make sure that all exhaust system flanges and
sealing surfaces are free of debris or damage that may
prevent a tight seal.
1. Install new exhaust gasket (item 13) if gasket was
removed. Do not use any type of gasket sealant on gas-
ket or flange surfaces.
2. Install all removed exhaust system components us-
ing Figure 4 as a guide. Hand tighten exhaust system
fasteners and after all exhaust system components
have been installed, fully tighten the fasteners as shown
in Figure 5:
A. Tighten flange head screws that secure muffler
bracket to engine bellhousing.
B. Tighten carriage screws and flange nuts that se-
cure exhaust muffler to muffler bracket.
C. Tighten flange nuts that secure exhaust header
to engine exhaust manifold.
D. Tighten clamp that secures exhaust muffler to ex-
haust header.
E. Tighten flange head screw and flange nut that se-
cures exhaust muffler to tailpipe bracket.
F. Tighten flange head screws that secure tailpipe
bracket to engine bellhousing.
Reelmaster 5010- H
3. Adjust muffler guard (item 15) on frame so there is
⅜" (9.5 mm) clearance between exhaust tailpipe and
guard in all directions.
4. After all exhaust components have been installed,
lower and secure hood.
C
F
Page 3 - 7
D
B
A
E
Figure 5
Kubota Diesel Engine