Toro Reelmaster 5010- H Service Manual page 280

Factor
Cutting unit alignment and carrier frame ground
following
Roller condition and roller type
Turf compensation spring adjustment
Rear lift arm counterbalance spring adjustment
Cutting unit accessories
Cutting Units
Possible Problem/Correction
Check carrier frames and lift arms for damage, binding
conditions or bushing wear. Repair if necessary.
Make sure rollers rotate freely. Repair roller bearings
as necessary.
See Roller Service in the Service and Repairs section
of this chapter.
Refer to Cutting Unit Operator's Manual for roller
options.
Refer to Traction Unit Operator's Manual for
adjustment procedure.
Refer to Traction Unit Operator's Manual for
adjustment procedure.
A variety of cutting unit accessories are available that
can be used to enhance aftercut appearance. Refer to
Cutting Unit Operator's Manual for a listing of available
accessories.
Page 7 - 10 Reelmaster 5010- H