General Information; Groomer Kit Installation Instructions; 48 Vdc Battery Disconnect - Toro Reelmaster 5010- H Service Manual

General Information

Groomer Kit Installation Instructions

The groomer kit installation instructions provides infor-
mation regarding the installation, set- up and operation
of the optional groomer on your Reelmaster machine.
Refer to this publication for additional information when
servicing the groomer.

48 VDC Battery Disconnect

CAUTION
Before installing, removing or servicing compo-
nents in the 48 VDC system (e.g. cutting unit mo-
tors, motor/generator), separate the 48 VDC bat-
tery disconnect. This will prevent unexpected
operation of 48 VDC system components.
The 48 VDC battery disconnect is attached to the right
frame rail under the operator seat (Fig. 1). Unplug the
disconnect to make sure that 48 VDC components do
not operate unexpectedly. Apply dielectric grease to the
contact surfaces of the battery disconnect and plug the
battery disconnect back in after service to the 48 VDC
system is completed.
Groomer
FRONT
1
1. RH frame rail
Page 8 - 2
2
Figure 1
2. 48V battery disconnect
Reelmaster 5010- H