Toro Reelmaster 5010- H Service Manual page 243

Removal (Fig. 3)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Chock wheels to prevent machine from shifting.
3. Loosen, but do not remove, wheel lug nuts.
CAUTION
When changing tires, attachments or perform-
ing other service, use correct hoists, jacks and
jack stands. Make sure machine is parked on a
solid, level surface such as a concrete floor.
Prior to raising machine, remove any attach-
ments that may interfere with the safe and prop-
er raising of the machine. Always chock or
block wheels. Use jack stands or other ap-
propriate load holding devices to support the
raised machine. If the machine is not properly
supported, the machine may move or fall, which
may result in personal injury.
4. Using a jack, raise machine so wheel is off ground
(see Jacking Instructions in Chapter 1 - Safety). Sup-
port machine with jack stands.
5. Remove wheel lug nuts and then remove wheel from
machine.
Reelmaster 5010- H
Installation (Fig. 3)
1. Install wheel and secure with five (5) wheel lug nuts.
2. Lower machine to ground.
Failure to maintain proper wheel lug nut torque
could result in failure or loss of wheel and may
result in personal injury.
3. Torque wheel lug nuts evenly in a crossing pattern
from 70 to 90 ft- lb (95 to 122 N- m).
Page 6 - 5
WARNING
Chassis