Toro Reelmaster 5010- H Service Manual page 215

8. Use a multimeter to check resistance of the fuel
sender across the two (2) sender terminals (Fig. 80).
A. Resistance with the float in the full position (com-
pletely up) should be from 5 to 8 ohms.
B. Resistance with the float in the empty position
(completely down) should be from 89 to 95 ohms.
9. Replace fuel sender if testing determines that it is
faulty.
10.After testing, install sender into fuel tank and secure
with gasket and fuel sender cap. Make sure that fuel fit-
tings on sender are orientated at 90
tank as shown in Figure 79. Also, to prevent damage to
fuel sender during assembly, make sure that fuel sender
does not turn as sender cap is tightened.
11. Install fuel hoses to fittings on sender and secure
with hose clamps. Connect fuel sender connector to
wire harness.
12.Secure sender cover to fuel tank with removed
screws.
Reelmaster 5010- H
o
from right side of
1. Sender full position
Page 5 - 75
1
o
90
2
Figure 80
2. Sender empty position
Electrical System