Toro Reelmaster 5010- H Service Manual page 97

Disassembly (Fig. 53)
1. Park the machine on a level surface, engage parking
brake, lower cutting units and stop engine. Remove key
from the ignition switch.
2. Remove components from piston (traction) pump
control assembly as needed using Figures 53 and 54 as
guides.
Assembly (Fig. 53)
IMPORTANT: To prevent traction neutral switch
(item 17) damage, make sure that no pump control
components contact switch through entire piston
(traction) pump control arm movement.
1. Install removed components to piston (traction)
pump control assembly using Figures 53 and 54 as
guides along with the following:
A. If traction neutral switch (item 17) was removed
from pump plate, adjust location of switch so that
there is from 0.094" to 0.100" (2.4 to 2.5 mm) clear-
ance between the head of neutral switch and the pis-
ton (traction) pump lever (Refer to Traction Neutral
Switch in the Adjustments section of Chapter 5 -
Electrical System for additional neutral switch infor-
mation).
2. After piston (traction) pump control assembly has
been installed, make sure that the piston pump is ad-
justed for the neutral position so that the machine does
not move or creep when the traction pedal is in neutral
(see Traction Unit Operator's Manual).
Reelmaster 5010- H
1
2
4
1. Pump lever
2. Traction neutral switch
3. Traction control cable
1
1. Piston pump
2. Pump lever
Page 4 - 61
5
Figure 54
4. Cable jam nut
5. Cable rod end
3
0.094" to 0.100"
(2.4 to 2.5 mm)
Figure 55
3. Traction neutral switch
Hydraulic System
3
2