Bedbar Assembly - Toro Reelmaster 5010- H Service Manual

Bedbar Assembly

7" CUTTING REEL SHOWN
12
RIGHT
FRONT
1. Bedbar assembly
2. Flange bushing (2 used)
3. Plastic washer (4 used)
4. Metal washer (2 used)
5. Bedbar pivot bolt (2 used)
Bedbar Removal (Fig. 21)
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. To prevent unexpected reel motor operation, discon-
nect motors from the electrical power supply by unplug-
ging the 48 VDC battery disconnect (see 48 VDC
Battery Disconnect in the General Information section of
this chapter).
Cutting Units
10
11
13
14
Figure 21
6. Lock nut (2 used)
7. Lock nut (2 used)
8. Compression spring (2 used)
9. Washer (2 used)
10. Bedbar adjuster screw (2 used)
3. Remove the cutting unit from the machine. Use the
cutting unit kickstand to support the cutting unit (see
Special Tools in this chapter).
4. Loosen the lock nuts (item 7) on the end of each bed-
bar adjuster assembly until washer (item 9) is loose.
5. Loosen the lock nuts (item 6) on each bedbar pivot
bolt (item 5).
Page 7 - 16
7
8
9
1
3
2
3
4
Antiseize
Lubricant
11. Cutting unit frame
12. RH side plate
13. Cutting reel assembly
14. LH side plate
Reelmaster 5010- H
5
6