Toro Reelmaster 5010- H Service Manual page 261

IMPORTANT: When removing the seat suspension,
make sure to support the control arm to prevent
damage to the control arm electrical components
and control arm wiring harness.
Removal (Figs. 18 and 19)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Disconnect negative battery cable from 12 VDC bat-
tery (see 12 Volt Battery Service in the Service and Re-
pairs section of Chapter 5 - Electrical System).
3. Remove seat from machine (see Operator Seat in
this section).
IMPORTANT: Take care to not damage the electrical
harness when removing seat suspension from ma-
chine.
4. Tilt and support seat frame to allow access to seat
suspension fasteners.
5. Support seat suspension to prevent it from falling.
Remove four (4) flange head screws (item 8 in Figure
19) and flange nuts (item 5 in Figure 19) that secure seat
suspension with attached seat brackets to seat base.
6. Remove seat suspension assembly from machine.
Locate and retrieve four (4) spacers (item 7 in Figure 19)
from between seat suspension assembly and seat
base.
7. Remove seat suspension components as needed
using Figures 18 and 19 as guides.
Installation (Figs. 18 and 19)
1. Install all removed seat suspension components us-
ing Figures 18 and 19 as guides.
A. If seat adjusters (items 12 or 13 in Figure 19) were
removed from seat suspension, install adjuster studs
in rear set of holes in the suspension. Also, make
sure that washer (item 9 in Figure 19) is placed be-
tween seat adjuster and suspension.
IMPORTANT: Take care to not damage the electrical
harness when installing seat suspension to ma-
chine.
Reelmaster 5010- H
2. Position seatbase cover and four (4) spacers (item
7 in Figure 19) to seat base.
3. Position seat suspension with attached seat brack-
ets to seat base. Use rear set of mounting holes in seat
brackets when aligning seat suspension assembly with
seat base. Secure with four (4) flange head screws (item
8 in Figure 19) and flange nuts (item 5 in Figure 19).
4. Install seat to machine (see Operator Seat in this
section). Make sure to connect wire harness electrical
connector to the seat switch.
5. Connect negative battery cable to 12 VDC battery
(see 12 Volt Battery Service in the Service and Repairs
section of Chapter 5 - Electrical System).
11
10
5
FRONT
1. Seat suspension
2. Seat bracket (2 used)
3. Screw (4 used)
4. Seat base
5. Flange nut (8 used)
6. Seatbase cover
7. Spacer (4 used)
Page 6 - 23
12
9
3
7
6
5
Figure 19
8. Flange screw (4 used)
9. Flat washer (4 used)
10. Manual tube
11. R- clamp (2 used)
12. Seat adjuster
13. Seat adjuster w/latch
13
1
8
2
4
Chassis