Rear Roller Brush Drive System (Optional) - Toro Reelmaster 5010- H Service Manual

Rear Roller Brush Drive System (Optional)

2
Grease
Grommet ID
Loctite #242
RIGHT
FRONT
1. Carriage screw (2 used)
2. Carriage screw (3 used)
3. Brush plate
4. Cap screw (2 used)
5. Flat washer (4 used)
6. Lock nut (6 used)
7. Idler arm
8. Idler spacer
NOTE: Drive components for the rear roller brush are
located on the opposite side of the cutting unit from the
cutting reel motor. Figure 44 shows components used
when the brush drive is on the left side of the cutting unit.
NOTE: The Installation Instructions for the rear roller
brush kit has detailed information regarding assembly
and adjustment. Use those Instructions along with this
Service Manual when servicing the rear roller brush.
Disassembly (Fig. 48)
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. To prevent unexpected reel motor operation, discon-
nect motors from the electrical power supply by unplug-
ging the 48 VDC battery disconnect (see 48 VDC
Battery Disconnect in the General Information section of
this chapter).
Cutting Units
1
3
15
5
6
19
15 to 19 ft- lb
(20 to 25 N- m)
9. Idler spring
10. Pivot washer
11. Drive belt
12. Idler pulley
13. Retaining ring
14. Bearing
15. Shoulder screw
Loctite #242
2
4
5
6
7
18
8
17
Loctite #242
35 to 40 ft- lb
(48 to 54 N- m)
Figure 48
3. Remove cover (item 20) to access rear roller brush
drive components.
4. Remove roller brush drive components as neces-
sary using Figure 48 as a guide.
5. Remove roller brush drive shaft if needed (Fig. 49):
A. Remove socket head screws that secure drive
housing to cutting unit side plate and remove hous-
ing from cutting unit.
IMPORTANT: If rear roller brush drive is on left
side of cutting unit, drive shaft has left hand
threads and can be identified by a groove on the
flange. If the rear roller brush drive is on right
side of cutting unit, drive shaft has right hand
threads and does not have a groove on the flange
(Fig. 50).
B. Loosen and remove drive shaft from cutting reel.
Page 7 - 36
15 to 19 ft- lb
(20 to 25 N- m)
10 to 15 ft- lb
9
(14 to 20 N- m)
10
6
11
13
14
6
16
12
16. Flange head screw
17. Drive pulley
18. Spacer
19. Flange bushing
20. Cover
21. Flange nut (2 used)
22. Set screw (top of cover only)
Reelmaster 5010- H
v
22
20
21