Toro Reelmaster 5010- H Service Manual page 229

8. If cutting reel motor is to be removed from machine,
disconnect reel motor cable from machine wire harness
(Figs. 92 and 93):
A. Locate reel motor cable electrical connections at
machine wire harness for motor that is to be re-
moved.
B. Disconnect two (2) motor cable connectors from
machine wire harness.
C. Remove flange nut that secures reel motor cable
connector plate to machine frame and separate mo-
tor cable from machine.
D. Locate and loosen bulkhead nut that secures reel
motor cable to bulkhead bracket on machine. Sepa-
rate cable from bracket.
9. Remove cutting reel motor with attached cable from
machine.
Installation
NOTE: Refer to Figure 94 for correct placement of cut-
ting unit reel motors and weights.
1. Install new O- ring to flange of cutting unit motor.
Coat spline shaft of the reel motor with No. 2 multipur-
pose lithium base grease.
2. Remove protective plastic cap from the hole in the
cutting unit side plate.
3. Make sure that the two (2) cap screws for the cutting
reel motor are installed into the cutting unit side plate
with approximately 1/2 inch (12.7 mm) of threads ex-
posed on each screw.
4. Secure cutting reel motor to cutting unit (Fig. 91):
A. Rotate the motor clockwise so the motor flanges
clear the cap screws in the cutting unit side plates.
Align reel motor shaft splines with cutting reel insert
splines. Slide motor shaft into cutting reel threaded
insert. Make sure that cable is on the upper side of
the motor after installation.
B. Rotate the motor counterclockwise until the mo-
tor flanges are encircling the cap screws in the cut-
ting unit side plates. Tighten two (2) cap screws to
secure cutting reel motor to cutting unit.
Reelmaster 5010- H
5. If cutting reel motor was removed from machine,
connect reel motor cable to machine wire harness (Fig.
93):
A. Connect two (2) reel motor cable connectors to
machine wire harness.
B. Position reel motor cable connector plate to ma-
chine frame and secure with flange nut.
C. Position reel motor cable to bulkhead bracket on
machine and tighten bulkhead nut.
6. Lubricate grease fitting on cutting unit side plate that
includes reel motor.
7. After completing installation of all cutting unit motors,
plug the 48 VDC battery disconnect back into the socket.
4
2
FRONT
1. Reel motor location
Page 5 - 89
2 1
1
3
Figure 94
2. Weight location
Electrical System
5