Toro Reelmaster 5010- H Service Manual page 276

Spline Insert Tool
Toro Part Number: TOR4112 (8 tooth for 5 inch reels)
TOR4074 (9 tooth for 7 inch reels)
Use spline insert tool for rotating cutting reel when motor
is removed. Also use this tool for installation of threaded
inserts into cutting reel shaft.
Rear Roller Bearing and Seal Installation Tools
Toro Part Number: 115- 0803
This tool kit is used to assemble the cutting unit rollers.
Tools in this kit are also available individually as follows:
115- 0852 Inner Seal Tool
115- 0853 Bearing/Outer Seal Tool
107- 8133 Bearing Installation Washer
Plastic Plug
Toro Part Number: 2410- 30 (for 5 inch reels)
94- 2703 (for 7 inch reels)
This cap is used for placement into the cutting unit side
plate when the cutting reel motor is removed. It prevents
dirt and debris from entering the cutting reel bearing
area.
Cutting Units
Inner Seal
Tool
Page 7 - 6
Figure 9
Bearing Installation
Washer
Bearing/Outer Seal
Figure 10
Figure 11
Reelmaster 5010- H
Tool