Lift Cylinder Service - Toro Reelmaster 5010- H Service Manual

Lift Cylinder Service

1
14
13
40 ft- lb
(54 N- m)
9
13
1. Grease fitting
2. Shaft
3. Dust seal
4. Head
5. BS seal
NOTE: The front, outside lift cylinders are longer with
more stroke than the other lift cylinders which are identi-
cal. Service procedures for all lift cylinders used on Re-
elmaster 5010- H machines are the same.
Disassembly (Fig. 76)
1. Remove oil from lift cylinder into a drain pan by slowly
pumping the cylinder shaft. Plug both ports and clean
the outside of the cylinder.
Hydraulic System
9
10
11
12
12 14
10 11
6. Retaining ring
7. Back up washer
8. O- ring
9. Piston
10. Wear ring
4
7
8
5
4 5 3
8 7 6
Figure 76
IMPORTANT: Prevent damage when clamping the
lift cylinder into a vise; clamp on the clevis end of
the barrel ONLY.
2. Mount lift cylinder securely in a vise by clamping on
the clevis end of the barrel. Use of a vise with soft jaws
is recommended.
Page 4 - 92
3
6
2
2
11. BP seal
12. O- ring
13. Lock nut
14. Barrel
15. Grease fitting
Reelmaster 5010- H
15