Toro Reelmaster 5010- H Service Manual page 289

4. After installing bedknife to bedbar, grind bedknife.
Bedknife Grinding
Since there can be variations in the mounting surface of
the bedbar, a new bedknife will not be perfectly flat after
it is installed to the bedbar. Because of this, it is neces-
sary to grind a new bedknife after installing it to the bed-
bar. Follow the existing angle that was ground into the
bedknife and grind only enough to make sure the top
surface of the bedknife is true (Fig. 25).
IMPORTANT: When grinding the bedknife, be care-
ful to not overheat the bedknife. Remove small
amounts of material with each pass of the grinder.
Also, clean and dress grinding stone often during
the grinding process.
1. Use Cutting Unit Operator's Manual, Toro General
Service Training Book, Reel Mower Basics (part no.
09168SL) and grinder manufacturer's instructions for
bedknife grinding information.
2. After grinding bedknife, check lead- in chamfer on
bedknife (see Cutting Unit Operator's Manual).
3. After bedknife grinding is complete, install bedbar to
cutting unit (see Bedbar Assembly in this section).
NOTE: After grinding the reel and/or bedknife, check
the reel to bedknife contact again after cutting two (2)
fairways. During this initial use, any burrs will be re-
moved from reel and bedknife which may create improp-
er reel to bedknife clearance and thus accelerate wear.
This practice of re- checking the reel to bedknife contact
after grinding will extend the longevity of the sharpness
of the edge of the reel and the bedknife.
Reelmaster 5010- H
Bedknife Grinding Specifications (see Fig. 25)
Bedknife Top Angle
Bedknife Front Angle
Extended Bedknife Front Angle
1
2
1. Bedknife
Page 7 - 19
o
10
o
5
o
10
0.250"
(6.4 mm)
0.060"
(1.5 mm)
Figure 26
2. Lead- in chamfer
Cutting Units