Main Information Screens - Toro Reelmaster 5010- H Service Manual

Main Information Screens

The two (2) InfoCenter main information screens (Figs.
13 and 14) are displayed after the initial splash screen
has been displayed for several seconds. During normal
machine operation, the main information screens
provide machine information for the operator. Toggling
between the main information screens is done by press-
ing the right button on the InfoCenter.
The main information screens can be used to monitor
engine coolant temperature, fuel tank level, 48 VDC bat-
tery voltage, engine RPM, motor/generator temperature
and traction speed range. The screens will also identify
if the parking brake is applied or if the cutting decks are
engaged.
The main information screens will also display arrows
whenever the cutting deck sections are either raising
(up arrows) or lowering (down arrows).
If controls are not selected properly to allow certain ma-
chine operations, the InfoCenter indicator light will illu-
minate and an advisory will be displayed on the
InfoCenter Display (see Advisories in the Troubleshoot-
ing section of this chapter). Typically, an advisory can be
eliminated with a change in controls by the operator.
If an electrical machine fault occurs during machine op-
eration, the InfoCenter indicator light will blink to notify
the operator. Accessing the fault log is described below
in Faults Screen.
The main menu and additional information screens can
be accessed from the InfoCenter main information
screen by pressing and releasing the menu/back button
(left button) on the display. Information on the main
menu and menu item screens is included below.
Reelmaster 5010- H
4
3
100
2
1
8
1. Parking brake applied
2. Traction speed range
3. Coolant temperature
4. Indicator light
3
2
100
1
8
1. Engine RPM
2. Coolant temperature
3. Indicator light
4. Generator temperature
Page 5 - 11
170
240
N
P
7 6
Figure 13
5. Fuel gauge
6. Right button
7. Middle button
8. Menu/back button
170 190
240 260
120
RPM
1400 52.3V
6
7
Figure 14
5. 48 VDC battery voltage
6. Right button
7. Middle button
8. Menu/back button
Electrical System
5
4
5