Infocenter Display; Infocenter Display; Splash Screen - Toro Reelmaster 5010- H Service Manual

InfoCenter Display

The InfoCenter Display used on your Reelmaster is a
LCD device that is located on the console. The InfoCent-
er provides information for the machine operator during
machine operation, provides electrical system diagnos-
tic assistance for technicians and allows inputs for ad-
justable machine settings.

Splash Screen

The InfoCenter splash screen (Fig. 12) is displayed
when the ignition switch is initially turned to the ON/
PREHEAT or START position. The splash screens allow
basic machine information to be reviewed by the operat-
or. After the splash screens has been on the InfoCenter
for several seconds, the main information screen will be
displayed on the InfoCenter.
The splash screen can be used to identify machine 12
VDC battery voltage, hourmeter reading, fuel tank level
and whether the glow plugs are energized.
Electrical System
Power for the InfoCenter is available when energized by
the main power relay (ignition switch in the ON/PRE-
HEAT or START position). CAN- bus systems involving
the machine TEC controller, the InfoCenter, the motor/
generator and the cutting unit motors are used to pro-
vide necessary machine communication for InfoCenter
operation.
NOTE: Icons that are used on the InfoCenter display
are identified in the Traction Unit Operator's Manual.
1
7
1. 12 VDC battery voltage
2. Hour meter
3. Fuel gauge
4. Glow plugs energized
Page 5 - 10
2
T
12.6V 95.2
6
Figure 12
5. Right button
6. Middle button
7. Menu/back button
Reelmaster 5010- H
3
4
5