Toro Reelmaster 5010- H Service Manual page 287

6. Remove two (2) bedbar pivot bolts (item 5), two (2)
metal washers (item 4) and four (4) plastic washers
(item 3) from the cutting unit side plates.
CAUTION
Contact with the reel, bedknife or other cutting
unit parts can result in personal injury. Use
heavy gloves when handling the bedbar.
7. Remove bedbar assembly from cutting unit.
8. Inspect flange bushings (item 2) and rubber bush-
ings in side plates for wear or damage. Remove bush-
ings and replace if necessary.
Bedbar Installation (Fig. 21)
1. If rubber bushing was removed from either cutting
unit side plate, install a new bushing. The bushing
should be installed flush with the inside of the side plate
(Fig. 22).
2. If removed, install the flange bushings (item 2) with
flange facing outward. Apply antiseize lubricant to inside
of flange bushing.
3. Apply antiseize lubricant to the bedbar threads and
the shoulder area of each bedbar pivot bolt.
4. Slide one metal washer (item 4) and one plastic
washer (item 3) onto each bedbar pivot bolt.
CAUTION
Contact with the reel, bedknife or other cutting
unit parts can result in personal injury. Use
heavy gloves when handling the bedbar.
5. Position bedbar into cutting unit. Make sure that the
top of each bedbar arm is between washer (item 9) and
adjuster screw flange (item 10).
Reelmaster 5010- H
6. Position a plastic washer (item 3) between bedbar
and each cutting unit side plate (Fig. 22).
7. Install the bedbar pivot bolt assemblies. Make sure
that plastic washers are not caught on the threads of the
pivot bolts. Tighten each bedbar pivot bolt from 27 to 33
ft- lbs (37 to 44 N- m).
8. Tighten both lock nuts (item 6) until outside metal
washer just stops rotating. Do not over tighten the lock
nuts as this can distort the side plates and affect reel
bearing adjustment. The plastic washer between the
bedbar and side plate should be loose.
9. Tighten the lock nut (item 7) on each bedbar adjuster
assembly until the adjuster spring is fully compressed,
then loosen lock nut 1/2 turn.
10.Adjust cutting unit (see Cutting Unit Operator's
Manual).
11. Install cutting unit to machine.
12.Plug the 48 VDC battery disconnect back in before
operating the machine.
6
1. Cutting unit sideplate
2. Rubber bushing
3. Flange bushing
4. Washer (plastic)
Page 7 - 17
Antiseize
1 8
Lubricant
5
4
4
2
Figure 22
5. Washer (metal)
6. Bedbar
7. Bedbar pivot bolt
8. Lock nut
Cutting Units
7
3