Cutting Reel Assembly Removal And Installation; Reel Assembly Removal - Toro Reelmaster 5010- H Service Manual

Cutting Reel Assembly Removal and Installation

7" CUTTING REEL SHOWN
17
18
Antiseize
Lubricant
RIGHT
FRONT
1. Bedbar assembly
2. Cutting unit frame
3. Flange bushing (2 used)
4. Plastic washer (4 used)
5. Metal washer (2 used)
6. Bedbar pivot bolt (2 used)
NOTE: This section provides the procedure for remov-
ing and installing the cutting reel assembly (cutting reel,
spline inserts, seals and bearings) from the cutting unit.
Refer to Reel Assembly Service later in this section for
information on replacing cutting reel seals and bearings.
NOTE: Removal of the cutting reel requires removal of
the left side plate (item 9) from the cutting unit frame.
The right side plate (item 8) does not have to be re-
moved from the frame.
Cutting Units
8
2
7. Lock nut (2 used)
8. RH side plate
9. LH side plate
10. Weight
11. Cap screw (2 used)
12. O- ring
15
13
27 to 33 ft- lb
(37 to 44 N- m)
14
9
12
Antiseize
Lubricant
Figure 28
Reel Assembly Removal (Fig. 28)
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. To prevent unexpected reel motor operation, discon-
nect motors from the electrical power supply by unplug-
ging the 48 VDC battery disconnect (see 48 VDC
Battery Disconnect in the General Information section of
this chapter).
3. Remove the cutting unit from the machine and place
it on a flat work area.
Page 7 - 22
1
4
3
4
5
10
Antiseize
Lubricant
11
13. Cutting reel assembly
14. Wire spring
15. Flange nut (3 used per side plate)
16. Shoulder bolt (3 used per side plate)
17. Cap screw (2 used)
18. O- ring
Reelmaster 5010- H
16
7
6