Toro Reelmaster 5010- H Service Manual page 291

Removal (Fig. 27)
1. Remove lock nut (item 3), compression spring (item
2) and washer (item 12) from bedbar adjuster screw
(item 4).
2. Remove bedbar (see Bedbar Assembly in this sec-
tion).
NOTE: Inside threads in bedbar adjuster shaft (item 10)
are left- hand threads.
3. Unscrew bedbar adjuster screw (item 4) from the
bedbar adjuster shaft (item 10).
4. Remove bedbar adjuster shaft (item 10) from cutting
unit frame:
A. Remove lock nut and flat washer from adjuster
shaft.
B. Slide adjuster shaft and wave washer from cut-
ting unit frame.
5. Inspect keyed flange bushings (item 5) in cutting unit
frame and remove if necessary.
6. If detent (item 7) is damaged, remove it from cutting
unit side plate by removing the cap screw (item 6).
Installation (Fig. 27)
1. If detent (item 7) was removed, secure detent to cut-
ting unit side plate with cap screw. Torque cap screw
from 14 to 16 ft- lb (19 to 21 N- m).
Reelmaster 5010- H
2. If keyed flange bushings (item 5) were removed from
cutting unit frame, apply antiseize lubrication to bushing
bore in cutting unit frame. Align key on bushing to slot in
frame and slide bushing into frame.
3. Install bedbar adjuster shaft (item 10) to cutting unit
frame:
A. Slide wave washer onto bedbar adjuster shaft
and then slide adjuster shaft into keyed flange bush-
ing in cutting unit frame.
B. Secure adjuster shaft with flat washer and lock
nut. Tighten lock nut to shoulder of adjuster shaft and
then torque lock nut from 15 to 20 ft- lb (21 to 27
N- m).
NOTE: Inside threads in bedbar adjuster shaft (item 10)
are left- hand threads.
4. Apply antiseize lubricant to threads of bedbar adjust-
er screw (item 4) that fit into bedbar adjuster shaft (item
10). Thread bedbar adjuster screw into adjuster shaft.
5. Install bedbar (see Bedbar Assembly in this section).
6. Install washer (item 12), compression spring (item 2)
and lock nut (item 3) onto bedbar adjuster screw. Tight-
en the lock nut on each bedbar adjuster assembly until
the compression spring is fully compressed, then loosen
lock nut 1/2 turn.
7. Adjust cutting unit (see Cutting Unit Operator's
Manual).
Page 7 - 21
Cutting Units