7. Check that excluder seals just touch groomer plate
assembly (Fig. 13). Reposition excluder seals on
groomer shaft if needed. Excluder seal ID should be lo-
cated on groomer shaft surface that is recessed slightly.
8. Check groomer reel height and mower height- of- cut
settings. Adjust as needed.
Reelmaster 5010- H
9. Lubricate groomer bearings.
10.Install cutting unit back on machine.
NOTE: After greasing groomer bearings, operate
groomer for thirty (30) seconds, stop machine and wipe
excess grease from groomer shaft and seals.
Page 8 - 13
Groomer