Specifications; Specifications - Toro Reelmaster 5010- H Service Manual

Specifications

Frame Construction: Precision machined die cast alu-
minum cross member with two (2) bolt- on aluminum
side plates.
Reel Construction: Reels are 22 inches (55.9 cm.) in
length and are available in 5 inch (12.7 cm) and 7 inch
(17.8 cm) diameters. High strength, low alloy steel
blades are thru hardened and impact resistant. 5 inch
and 7 inch reels are available in both 8 and 11 blade con-
figurations.
Reel Bearings: Two (2) sealed, stainless steel ball
bearings support the reel shaft with inboard spacer for
protection.
Reel Drive: The reel weldment shaft is a 1 5/16 inch
(33.3 mm) diameter tube with LH and RH drive inserts
threaded into both ends. The drive inserts for 5 inch re-
els have an internal eight (8) tooth spline. The drive in-
serts for 7 inch reels have an internal nine (9) tooth
spline.
Height- of- Cut (HOC): Cutting height is adjusted on
the front roller by two (2) vertical screws. Effective HOC
may vary depending on turf conditions, type of bedknife,
roller type and installed attachments.
Cutting Units
Figure 1
Bedknife: Replaceable, tool steel EdgeMax
is fastened to a machined cast iron bedbar with eight (8)
screws. Optional bedknives are available.
Bedknife Adjustment: Dual screw assemblies allow
for precise bedknife adjustment. Adjustment detents
correspond to bedknife movement for each indexed po-
sition as follows:
0.0007 inch (0.018 mm) for 5 inch reel
0.0009 inch (0.022 mm) for 7 inch reel
Front and Rear Rollers: Greaseable through- shaft
front and rear rollers are used with these cutting units.
All rollers use the same heavy duty, stainless steel ball
bearings and seal package.
Cutting Unit Weight (without end weight):
8 Blade, 5 inch reel
11 Blade, 5 inch reel
8 Blade, 7 inch reel
11 Blade, 7 inch reel
Options: Refer to Cutting Unit Operator's Manual for
available options for your Reelmaster cutting unit.
Page 7 - 2
bedknife
TM
90 lb. (41 kg)
93 lb. (42 kg)
118 lb. (54 kg)
121 lb. (55 kg)
Reelmaster 5010- H