<Command Entry Example>
An example of executing the command to show the telnet server configuration is shown
below.
M24eG> enable
M24eG# show telnet
(1)
Telnet UI Idle Timeout: 5 minutes
(2)
Telnet Access Limitation: Disabled
(3)
(4)
No.
IP Address
---
----------------
1
<empty>
2
<empty>
3
<empty>
4
<empty>
5
<empty>
M24eG#
Fig. 3-5-2-1 Example of executing the command to show the telnet server configuration
(1) Telnet UI Idle Timeout
Shows the maximum inactivity time to wait for a user input in a telnet client session. Upon
expiration, the session is automatically terminated.
(2) Telnet Access Limitation
Shows the access limitation settings from telnet clients.
Enabled
Disabled
(3) No.
Shows the entry number assigned to the access-limited address of a telnet client.
(4) IP Address
Shows the IP address or the IP address range to allow access from telnet clients. (If no
IP address has been entered, <empty> is shown.)
(5) Subnet Mask
Shows the subnet mask value for IP addresses to allow access from telnet clients.
(If no subnet mask value has been entered, <empty> is shown.)
(5)
Subnet Mask
----------------
<empty>
<empty>
<empty>
<empty>
<empty>
The access limitation from telnet clients is enabled.
The access limitation from telnet clients is disabled.
71