<Command Entry Example>
An example of executing the command to show the system information is shown below.
M24eG> enable
M24eG# show sys-info
System up for
Boot Code Version
Runtime Code version : x.x.x.xx
Hardware Information
Version
DRAM Size
Fixed Baud Rate
Flash Size
(1)
Administration Information
(5)
(2)
Switch Name
(3)
Switch Location
(4)
Switch Contact
System Address Information
MAC Address
IP Address
Subnet Mask
Default Gateway
M24eG#
Fig. 3-1-1 Example of executing the command to show the system information
Terms related to this section are explained below.
(1) Administration Information
Shows the Switching Hub's administration information.
(2) Switch Name
Shows the Switching Hub's current host name.
(3) Switch Location
Shows the Switching Hub's current installation location name.
(4) Switch Contact
Shows the Switching Hub's current contact information.
: 0 days, 00:00:00
: xx.xx.xx
: Version1
: 32MB
: 9600bps
: 8MB
:
:
:
: xx:xx:xx:xx:xx:xx
: 0.0.0.0
: 0.0.0.0
: 0.0.0.0
20