<Command Entry Example>
An example of executing the command to show the MAC address table (static entries)
is shown below.
M24eG> enable
M24eG# show mac-address-table static
(1)
MAC Address
----------------- ------------ ---- ---------
xx:xx:xx:xx:xx:xx Static
xx:xx:xx:xx:xx:xx Static
M24eG#
Fig. 3-6-4 Example of executing the command to show the MAC address table
(1) MAC Address
Lists MAC address entries existing in the MAC address table.
(2) Address Type
Shows the MAC address entry type.
Static
(3) VLAN
Shows the VLAN ID that is learning the MAC address entry.
(4) Port
Shows the interface name.
gi0/1
(2)
(3)
(4)
Address Type VLAN Port
1
gi0/1
1
gi0/1
(static entries)
Statically registered MAC address entry
Refers to "Gigabit Ethernet Port 1."
(The number after "gi0/" indicates the port number.)
103