Panasonic PN28160A Operation Manual page 130

<Command Entry Example>
An example of executing the command to show the VLAN configuration is shown below.
M24eG> enable
M24eG# show vlan all
(1)
NOTE -- 'U' : Untagged port member
'T' : Tagged port member
'-' : Not a port member
(2)
(3)
VLAN-ID | Status
Port No.
------- ---------- ---- ---- ---- ---- ---- ----
1 | static
| management |
10 | static
20 | static
M24eG#
Fig. 4-1-1 Example of executing the command to show the VLAN configuration
(1) NOTE
Describes the symbols output when the command to show the VLAN configuration is entered.
'U' : Untagged port member
'T' : Tagged port member
'-' : Not a port member
(2) VLAN-ID
Lists VLAN IDs currently registered in this Switching Hub.
(3) Status
Shows the VLAN-ID status in two lines.
static
management
* The Command Entry Example shows that only VLAN 1 belongs to the management VLAN,
and VLAN 10 and 20 do not.
(4)
|Name
(5)
|1234|5678|9012|3456|7890|1234
|VLAN1
|---- ---- UUUU UUUU UUUU UUUU
|VLAN10
|UUUU ---- ---- ---- ---- --TT
|VLAN20
|---- UUUU ---- ---- ---- --TT
'U' denotes an untagged port.
'T' denotes a tagged port.
'-' denotes a port that does not belong to the VLAN-ID.
Indicates that the VLAN-ID has been manually registered in this
Switching Hub.
(Only the data for VLAN-ID 1 is created at the factory.)
Indicates that the VLAN is a management VLAN that responds to
Ping, Telnet, and other remote access.
130