Table of Contents
Advertisement
<Command Entry Example>
An example of executing the command to show the detailed port information is shown
below.
M24eG> enable
M24eG# show interface gi0/1
(1)
Interface GigabitEthernet0/1
(2)
Admin Status
: Enabled
(3)
Auto Negotiate : Enabled
(4)
Flow Control
: Disabled
(5)
CoS Priority
: 0
(6)
MDIX Mode
: Crossover
(7)
Line Protocol : Up
(8)
Line Shut-down : 60 seconds
(9)
Power-saving
: Half
(10)
Max Frame Size : 1522 bytes
(11)
Accept Frames : VLAN tagged and untagged
M24eG#
Fig. 3-4-2 Example of executing the command to show the detailed port information
(1) Interface GigabitEthernet0/1
Shows the name of the interface whose detailed information is shown.
(The number after "GigabitEthernet0/" indicates the port number.)
(2) Admin Status
Shows whether the port is enabled or disabled.
Enabled
Disabled
(3) Auto Negotiate
Shows the auto negotiation setting.
Enabled
Disabled
(4) Flow Control
Shows the flow control setting.
Enabled
Disabled
(5) CoS Priority
Shows the priority of the queue in the QoS function.
(12)
Link Status
(13)
Duplex
(14)
Speed
(15)
Medium
(16)
PVID
The port is enabled.
The port is disabled.
The auto negotiation function is enabled.
The auto negotiation function is disabled.
The flow control is enabled.
The flow control is disabled.
47
: Up
: Full
: 100 Mbps
: Copper
: 1
Advertisement
Table of Contents
