<Command Entry Example>
An example of executing the command to show the link aggregation configuration is
shown below.
M24eG> enable
M24eG# show aggregation-link group
(1)
Aggregation Group <1>
(2)
Status
: Static
(3)
Criterion
: src-dst-mac
(4)
Admin Ports : gi0/9-10
(5)
Oper Ports : gi0/9-10
Aggregation Group <2>
Status
: Static
Criterion
: src-dst-mac
Admin Ports : gi0/20-24
Oper Ports : (none)
M24eG#
Fig. 4-2-1 Example of executing the command to show the link aggregation configuration
(1) Aggregation Group <1-8>
Shows the aggregation group ID.
(2) Status
Shows the aggregation group configuration status.
Static
(3) Criterion
Shows the traffic distribution type.
src-dst-mac
(4) Admin Ports
Shows the list of ports set in the aggregation group.
(5) Oper Ports
Shows the list of ports currently belonging to the aggregation group.
Shows "(none)" if none of the Admin Ports are linked up.
Indicates that the aggregation link is statically registered.
Traffic distribution is performed based on the destination MAC address
and the target MAC address of the transmitted frame.
149