Panasonic PN28160A Operation Manual page 12

Command-line Completion Support
• Enter a question mark (?) immediately after a command. This will show command
candidates to complete the entered command.
M24eG# configure
M24eG(config)# ip address
A.B.C.D - IP address (e.g. 10.0.0.1)
M24eG(config)# ip address
Abbreviated Command Entry
After entering just enough characters of a command or an argument to identify it uniquely,
you can omit the rest of the command or the argument.
[Example of Abbreviated Command Entry]
enable  en

show running-config  sh ru

[Bad Example of Abbreviated Command Entry]
co  Because both "configure" and "copy" are possible, an error occurs.

Symbols used in the command description are as follows:
< > : Required - You must enter this.
{ | } : Selections - Select one from the selections.
[ ] : Option - Enter as required.
Commands are case sensitive. Uppercase and lower case letters are treated as different letters.
Note that in this manual, ports are specified for Switch-M24eG (24 ports) except for a few
commands. When entering a command, make sure to specify existing port numbers of your
switch.
Fig. 1-3 Command-line completion support
12