Panasonic PN28160A Operation Manual page 160

<Command Entry Example>
An example of executing the command to show the access control is shown below.
M24eG> enable
M24eG# show AccessControl classifier all
Classifier Index
(1)
(2) VLAN ID :Ignore
(5) Protocol :Ignore
(8) Source MAC Address
(10) Destination MAC Adress
(12)
Source IP Address
(14)
Destination IP Address
(16)
Source Layer 4 Port
M24eG#
(1) Classifier Index
Shows the index number of the classifier.
(2) VLAN ID
Shows whether or not VLAN ID should be included in the target.
(3) 802.1p Priority
Shows whether or not IEEE 802.1p priority should be included in the target.
(4) DSCP
Shows whether or not DHCP should be included in the target.
(5) Protocol
Shows whether or not the protocol number should be included in the target.
(6) TCP SYN Flag
Shows whether or not TCP SYN flag should be included in the target.
(7) ICMP Type
Shows whether or not ICMP type should be included in the target.
(8) Source MAC Address
Shows whether or not the source MAC address should be included in the target.
(9) Source MAC Mask Length
Shows whether or not the mask length of the source MAC address should be included in
the target.
:1
(3)
802.1p Priority :Ignore
(6)
TCP SYN Flag :Ignore
(9)
:Ignore
(11)
:Ignore
(13)
:Ignore
(15)
:Ignore
(17)
:Ignore
Fig. 4-4-1 Classifier configuration display
(show AccessControl classifier all)
160
(4)
DSCP :Ignore
(7)
ICMP Type :Ignore
Source MAC Mask Length
Destination MAC Mask Length :Ignore
Source IP Mask Length
Destination IP Mask Length :Ignore
Destination Layer 4 port
:Ignore
:Ignore
:Ignore