Figure 3-64: Metering Tones; Table 3-34: Metering Tones Parameters - AudioCodes MediaPack MP-124 User Manual

SIP User's Manual
To configure the Metering tones, take these 4 steps:
Open the 'Metering Tones' page (Configuration tab > Protocol Configuration menu
1.
> SIP Advanced Parameters submenu > Metering Tones page item).
Configure the Metering tones parameters according to the table below.
2.
Click the Submit button to save your changes.
3.
To save the changes to the flash memory, refer to ''Saving Configuration'' on page
4.
209.
Note:
Parameter
Generate Metering Tones
[PayPhoneMeteringMode]
Metering Tone Type
[MeteringType]
Charge Codes Table
Version 5.6
Figure 3-64: Metering Tones Page
In the 'Tel to IP Routing' table (refer to ''Tel to IP Routing Table'' on page 160),
assign a charge code rule to the routing rules you require. When a new call is
established, the 'Tel to IP Routing' table is searched for the destination IP
addresses. Once a route is found, the Charge Code (configured for that route)
is used to associate the route with an entry in the 'Charge Codes' table.

Table 3-34: Metering Tones Parameters

Determines the method used to configure the metering tones that are
generated to the Tel side.
[0] Disable = Metering tones aren't generated (default).
[1] Internal Table = Metering tones are generated according to the
internal table configured by the parameter ChargeCode.
Notes:
This parameter is applicable only to FXS interfaces.
If you select 'Internal Table', you must configure the 'Charge Codes
Table' (refer to ''Charge Codes Table'' on page 146).
Defines the metering tone (12 or 16 kHz) that is generated by FXS
interfaces.
[0] 12 kHz = 12-kHz metering tone (default).
[1] 16 kHz = 16-kHz metering tone.
Note: A suitable (12 or 16 KHz) FXS Coefficient file must be used for
FXS interfaces.
If you configured the 'Generate Metering Tones' parameter to 'Internal
Table', access the 'Charge Codes Table' page, by clicking
detailed information on configuring the Charge Codes table, refer to
''Charge Codes Table'' on page 146.
Description
145
3. Web-Based Management
. For
November 2008