Configuring Wan Settings; Figure 34 Wan Settings Pppoe Screen - Billion BiGuard S10 Administration Manual

Configuring WAN settings

This menu item enables you to configure WAN settings and also to set WAN outbound and
inbound bandwidth parameters.
C WAN
ONFIGURING THE
You can select one of three protocols for the router's WAN settings: PPPoE, Static IP, and
Obtain an IP Address Automatically.
PPPoE protocol. Select this item if your ISP uses the PPPoE (Point-to-Point Protocol Over
Ethernet) protocol.
FIGURE 34 WAN S
Protocol Displays the current protocol. Click the drop-down arrow to change the
protocol.
Mode There are two modes for the connection: NAT (Network Address Transla-
tion) and Router.
NAT converts private IP addresses (such as in the 192.168.0.0 range) of
the machine on the internal private network to one or more public IP
addresses for the Internet. Select NAT to add an extra layer of security
when user on the internal network need to access the Internet. Select
Router for an internal network.
Username Type the user name that your ISP provided.
Password Type the password that your ISP provided.
Retype Confirm the password that your ISP provided.
Service Name Type the name of the ISP.
PPP E
ETTINGS O SCREEN
Configuring the BiGuard S10 39