Factory Default Settings; Username And Password; Lan And Wan Port Addresses - Billion BiGuard 10 User Manual

3.5 Factory Default Settings

Before configuring your BiGuard 2/10, you need to know the following default
settings:
Web Interface:
Username: admin
Password: admin
LAN Device IP Settings:
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
ISP setting in WAN site:
Obtain an IP Address automatically (DHCP Client)
DHCP server:
DHCP server is enabled.
Start IP Address: 192.168.1.100
End IP Address: 192.168.1.199

3.5.1 Username and Password

The default user name and password are "admin" and "admin" respectively.
If you ever forget your user name and/or password, you can restore your BiGuard
2/10 to its factory settings by holding the Reset button on the back of your router
until the Status LED begins to blink. Please note that doing this will also erase any
previous router settings that you have made. The Status LED will remain solid as the
device boots. Once the boot sequence is complete, the LED will shut off, indicating
that BiGuard 2/10 is ready.

3.5.2 LAN and WAN Port Addresses

The default values for LAN and WAN ports are shown below:
LAN Port WAN Port
27