Configuring Snmp; Figure 79 Enabling Snmp; Figure 80 Setting Snmp Parameters - Billion BiGuard S10 Administration Manual

66 Administration Guide

Configuring SNMP

Click SNMP to enable and disable Simple Network Management Protocol.
FIGURE 79
Click Enable. A screen appears allowing you to set SNMP parameters.
FIGURE 80
SNMP V1 and V2 This section enables you to set parameters for SNMP versions 1 and 2.
SNMP V3
E SNMP
NABLING
S SNMP
ETTING PARAMETERS
The following information is entered:
• Read Community: type the name of the read community and the IP
address associated with it.
• Write Community: type the name of the write community and the IP
address associated with it.
• Trap Community: type the name of the trap community and the IP
address associated with it.
This section enables you to set parameters for SNMP version 3. The fol-
lowing information is entered:
• Username and Password: type the user name and password for
accessing SNMP sites.
• Access Right: click Read if you only want users to have read
access rights. Click Read/Write if you want users to have read and
write access rights.