Configuring The Wan For Dhcp - Billion BiGuard S10 Administration Manual

2. Click WAN. The Quick Start WAN screen appears.
3. Select PPPoE from the Protocol drop-down menu.
4. Type the user name in the Username field.
5. Type and confirm the password in the Password and Retype Password fields.
6. Select Always On or Connect on Demand from the Connection drop-down menu.
If you select Connect on Demand, the following Idle Timeout field is available.
7. Type the number (of minutes) in the Idle Timeout field. If your connection is Connect on
Demand, you are disconnected after the idle timeout period.
8. Check Obtain DNS Automatically if your ISP provides this with the assigned IP. Other-
wise, enter the Primary and Secondary DNS provided by your ISP.
9. Click Apply to confirm the settings.

Configuring the WAN for DHCP

Configure the WAN for DHCP to enable the BiGuard S10 to automatically assign IP addresses
to client stations.
Refer to the following to configure the connection:
1. Click Quick Start in the Menu bar.
2. Click WAN. The Quick Start WAN screen appears.
3. Select Obtain an IP Address Automatically from the Protocol drop-down menu.
4. Check Obtain DNS Automatically if your ISP provides this with the assigned IP. Other-
wise, enter the Primary and Secondary DNS provided by your ISP.
5. Click Apply to confirm the settings.
Basic Configuration with the Quick Start Menu 23