Username And Password; Lan And Wan Port Addresses - Billion BiGuard 50G User Manual

ISP setting in WAN site:
Obtain an IP Address automatically (DHCP Client)
DHCP server:
DHCP server is enabled.
Start IP Address: 192.168.1.100
End IP Address: 192.168.1.199
3.5.1 User Name and Password
The default user name and password are "admin" and "admin" respectively.
If you ever forget your user name and/or password, you can restore your BiGuard
50G to its factory settings by holding the Reset button on the back of your router
until the Status LED begins to blink. Please note that doing this will also erase any
previous router settings that you have made. The Status LED will remain solid as the
device boots. Once the boot sequence is complete, the LED will shut off, indicating
that BiGuard 50G is ready.

3.5.2 LAN and WAN Port Addresses

The default values for LAN and WAN ports are shown below:
LAN Port
IP address 192.168.1.254
Subnet 255.255.255.0
Mask
DHCP server Enabled
function
IP 100
addresses continuing
for 192.168.1.100
distribution through
to PCs 192.168.1.199
WAN Port
The DHCP Client is enabled
to automatically get the
WAN
from the ISP.
IP addresses
from
60
port configuration