Recovery; Troubleshooting Sequence - Billion BiGuard S10 Administration Manual

Recovery

You can restore your BiGuard S10 to its factory settings by performing a recovery of the router.
You should perform this procedure in the event a software or hardware reset is not effective.
Performing a recovery of the router will rest all settings and return the router to
the settings it as when you first installed it. To reset the router without erasing all
your settings, perform a software reset.
Follow the instructions to perform a hardware reset.
1. Manually setup your administrator PC's IP to the following address:
NOTE:
RANGE IS
2. Switch off the power on your BiGuard S10 Series.
3. Hold down the reset button and switch on the power
4. When the status LED in the front panel blinks 3 times and then remains lit, release the
reset button.
5. Wait for six seconds, then open your browser and enter the IP address 192.168.1.254 in
the address bar. You will see the recovery mode page.
6. Follow the on-screen instructions.
NOTE:
DEALER FOR FURTHER INSTRUCTIONS

Troubleshooting sequence

This section answers some common questions about the BiGuard S10 operation and provides
some troubleshooting tips.
QUESTION: What's the LED sequence of the BiGuard S10 Series when powering on?
T IP
HE ADDRESS
192.169.1.0~24
LAN
4 3 2 1
Reset button
I
F ALL OF THE ABOVE PROCEDURES STILL DO NOT WORK
12V DC
RESET
OFF ON
WAN
Power button
.
,
CONTACT YOUR