Changing The Default Lan Ip Address; Dhcp Server Settings; Figure 22 Ethernet Screen; Figure 23 Dhcp Status Screen - Billion BiGuard S10 Administration Manual

Changing the default LAN IP address

Click IP Address in the Status screen. The Ethernet screen lets you change default LAN IP
address settings.
FIGURE 22 E
THERNET SCREEN
IP Address Type the preferred IP address.
Subnet Mask Type the preferred Subnet Mask.
RIP Click the drop-down arrow to enable Routing Information Protocol (RIP).
The options are: RIPv1; RIPv2; RIPv1 + RIPv2; RIPv2 Multicast; and
RIPv1 + RIPv2 Multicast.
Click Apply to update the new settings.

DHCP server settings

Click DHCP Server in the Status screen. The DHCP Server screen shows the current settings.
FIGURE 23 DHCP
The BiGuard S10 is enabled to act as a DHCP server for your network. Disable this function if
the stations that connect to the BiGuard S10 LAN ports use static IP addresses. To change
DHCP settings, see Configuring DHCP server settings
Monitoring Configuration Status
STATUS SCREEN
on page 37.
29