Configuring The Biguard S10; Configuring The Interface; Configuring The Lan; Figure 31 Lan Screen - Billion BiGuard S10 Administration Manual

36 Administration Guide

Configuring the BiGuard S10

This section explains how to configure router settings including the LAN, WAN, DMZ, how to
create network objects such as addresses, services, address and service groups, schedules,
bandwidth control items, and content blocking scenarios. You can also set up security policies
which includes configuring packet filtering, virtual servers, quality of service (QoS), and MAC
and content filters.
Additionally, you can perform system maintenance and configuration including configuring the
time zone, enabling remote access, upgrading the firmware, backing up and restoring configura-
tions, setting the log on password, and restarting the system.
Finally, you configure advanced features including setting up static routing, enabling DDNS and
SNMP, configuring the firewall, and managing router device parameters.

Configuring the Interface

Click Interface to configure the LAN, WAN, and DMZ.

Configuring the LAN

Click LAN to display the LAN submenu items: Ethernet and DHCP Server.
C
ONFIGURING THE
The Ethernet dialog lets you change default LAN IP address settings.
FIGURE 31
IP Address
Subnet Mask
RIP
E
THERNET
LAN
SCREEN
Type the preferred IP address. (default 192.168.1.254).
Type the preferred IP address.
Click the drop-down arrow to enable Routing Information Protocol (RIP).
The options are: Disabled; RIPv1; RIPv2; RIPv1 + RIPv2; RIPv2 Multicast;
and RIPv1 + RIPv2 Multicast.