Username And Password; Lan And Wan Port Addresses - Billion BiGuard 10 User Manual

IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
ISP setting in WAN site:
Obtain an IP Address automatically (DHCP Client)
DHCP server:
DHCP server is enabled.
Start IP Address: 192.168.1.100
End IP Address: 192.168.1.199

3.5.1 Username and Password

The default user name and password are "admin" and "admin" respectively.
If you ever forget your user name and/or password, you can restore your BiGuard
2/10 to its factory settings by holding the Reset button on the back of your router
until the Status LED begins to blink. Please note that doing this will also erase any
previous router settings that you have made. The Status LED will remain solid as the
device boots. Once the boot sequence is complete, the LED will shut off, indicating
that BiGuard 2/10 is ready.

3.5.2 LAN and WAN Port Addresses

The default values for LAN and WAN ports are shown below:
LAN Port
IP address 192.168.1.254
Subnet Mask 255.255.255.0
DHCP server
Enabled
function
IP addresses for 100 IP addresses continuing
distribution to from 192.168.1.100 through
PCs 192.168.1.199
WAN Port
The DHCP Client is enabled to
automatically get the WAN port
configuration from the ISP.
48