Safety Information - Billion BiGuard S10 Administration Manual

Safety Information

The BiGuard S10 is built for reliability and long service life. For your safety, be sure to read and follow the
following safety warnings.
Read this installation guide thoroughly before attempting to set up the BiGuard S10.
• The BiGuard S10 is a complex electronic device. DO NOT open or attempt to repair it yourself. Open-
ing or removing the covers can expose you to high voltage and other risks. In the case of malfunction,
turn off the power immediately and have it repaired at a qualified service center. Contact your vendor
for details.
• Connect the power cord to the correct supply voltage.
• Carefully place connecting cables to avoid people from stepping or tripping on them. DO NOT allow
anything to rest on the power cord and DO NOT place the power cord in an area where it can be
stepped on.
• DO NOT use the BiGuard S10 in environments with high humidity or high temperatures.
• DO NOT use the same power source for the BiGuard S10 as other equipment.
• DO NOT use the BiGuard S10 and any accessories outdoors.
• If you wall mount the BiGuard S10, make sure that no electrical, water or gas pipes will be damaged
during installation.
• DO NOT install or use the BiGuard S10 during a thunderstorm.
• DO NOT expose the BiGuard S10 to dampness, dust, or corrosive liquids.
• DO NOT use the BiGuard S10 near water.
• Be sure to connect the cables to the correct ports.
• DO NOT obstruct the ventilation slots on the BiGuard S10 or expose it to direct sunlight or other heat
sources. Excessive temperatures may damage your device.
• DO NOT store anything on top of the BiGuard S10.
• Only connect suitable accessories to the BiGuard S10.
• Keep packaging out of the reach of children.
• If disposing of the device, please follow your local regulations for the safe disposal of electronic prod-
ucts to protect the environment.
BiGuard S10 Administrator Guide iii