Introduction BiGuard 2 is a compact device of 8 ports switch integrated with VPN and Firewall features. It is used for home offices or mobile users to dial up and connect with corporate network, or for very small offices to be connected with head offices. BiGuard 2 is designed for business requiring application-based network solutions at low-capital investment and is perfectly for the needs of telecommuters and small sized business.
Quick Start Guide The Front LEDs Power A steady light indicates connection to power source STATUS A blinking light indicates device is writing flash Light when connect to an Ethernet device. 10/100M : Light when link for 100Mbps otherwise for 10Mbps LNK/ACT : Lit when device connected and blinking when data is transmitted/received.
— (RJ-45 connector) DC12V BiGuard 2 iBusiness Security Gateway Home-Office After the device is powered on, press it to reset the device or restore to factory default settings. 0-3 seconds: The Status LED will light 6 seconds above: Restore to factory default settings (this is used when you cannot login to the router.
Quick Start Guide Connecting Your Router 1. Connect the Router to a LAN (Local Area Network) & WAN (Connect to Cable or ADSL modem). 2. Power on the device. 3. Make sure the Power LED is light steadily and that the WAN and relevant LAN LED is light.
Properties. 4. Select Internet Protocol (TCP/IP) and click Properties. 5. Select the Obtain an IP address automatically and the Obtain DNS server address automatically radio buttons. 6. Click OK to finish the configuration. BiGuard 2 iBusiness Security Gateway Home-Office...
Quick Start Guide Configuring PC in Windows 2000 1. Go to Start / Settings / Control Panel. In the Control Panel, double-click on Network and Dial-up Connections. 2. Double-click Local Area Connection. 3. In the Local Area Connection Status window click Properties.
Network Interface Card (NIC) in your PC. 3. Select the Obtain an IP address automatically radio button. 4. Then select the DNS Configuration tab. 5. Select the Disable DNS radio button and click OK to finish the configuration. BiGuard 2 iBusiness Security Gateway Home-Office...
Page 10
Quick Start Guide Configuring PC in Windows NT4.0 1. Go to Start / Settings / Control Panel. In the Control Panel, double-click on Network and choose the Protocols tab. 2. Select TCP/IP Protocol and click Properties. 3. Select the Obtain an IP address from a DHCP server radio button and click OK.
Page 11
Connection fails, when you see “Request timed out” in the command prompt window. You may need to check your set up. BiGuard 2 iBusiness Security Gateway Home-Office then...
Most problems can be solved by referring to the Troubleshooting section in the User’s Manual. If you cannot resolve the problem with the Troubleshooting chapter, please contact the dealer where you purchased this product. Contact Billion WORLDWIDE http://www.billion.com/ Mac OS is a registered Trademark of Apple Computer, Inc.