Mld Snooping Querier Configuration Example - HP 6125G Configuration Manual

Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 1 port(s).
IP group(s):the following ip group(s) match to one mac group.
IP group address:FF1E::101
(::, FF1E::101):
MAC group(s):
MAC group address:3333-0000-0101
The output shows that GigabitEthernet 1/0/3 and GigabitEthernet 1/0/5 on Switch C have become
static member ports for IPv6 multicast group FF1E::101.

MLD snooping querier configuration example

Network requirements
As shown in
Source 2) send IPv6 multicast data to multicast groups FF1E::101 and FF1E::102 respectively, Host A and
Host C are receivers of multicast group FF1E::101 and Host B and Host D are receivers of multicast group
FF1E::102.
MLDv1 runs on all the receivers and MLDv1 snooping runs on all the switches. Switch A, which is close
to the multicast sources, is chosen as the MLD snooping querier.
To prevent flooding of unknown multicast traffic within the VLAN, configure all the switches to drop
unknown multicast data packets.
GE1/0/2
Attribute: Host Port
Host port(s):total 2 port(s).
GE1/0/3
GE1/0/5
Host port(s):total 2 port(s).
GE1/0/3
GE1/0/5
Figure 64, in a Layer-2-only network environment, two multicast sources (Source 1 and
(D) ( 00:01:23 )
(S)
(S)
232