Using The Wps Button (Dell B2375Dfw Mono Mfp Only); Items To Prepare; Choosing Your Type - Dell B2375dfw Mono User Manual

Using the WPS button (Dell B2375dfw Mono MFP only)

If your machine and an access point (or wireless router) support Wi-Fi Protected Setup™
(WPS), you can easily configure the wireless network settings by pressing the
button on the control panel without a computer.
• If you want to use the wireless network using the infrastructure mode, make
sure that the network cable is disconnected from the machine. Using the WPS
button or entering the PIN from the computer to connect to the access point
(or wireless router) varies depending on the access point (or wireless router)
you are using. Refer to the user's guide of the access point (or wireless router)
you are using.
• When using the WPS button to set the wireless network, security settings may
change. To prevent this, lock the WPS option for the current wireless security
settings. The option name may differ depending on the access point (or
wireless router) you are using.
• WPS button has two functions.
– Press and hold the
then wait for up to two minutes until you press the WPS (PBC) button on the
access point (or wireless router).
– If you Press and hold the
seconds, below manus are shown.
• Wi-Fi : You can turn the Wi-Fi on/off.
• Wi-Fi Direct : You can turn the Wi-Fi Direct on/off.
• WPS (Connect via PBC) : Connect your machine to a wireless network using
the PBC method.
• WPS (Connect via PIN) : Connect your machine to a wireless network using
the PIN method.

Items to prepare

• Check if the access point (or wireless router) supports Wi-Fi Protected Setup™ (WPS).
• Networked computer (PIN mode only)

Choosing your type

There are two methods available to connect your machine to a wireless network using the
(WPS) button on the control panel.
The Push Button Configuration (PBC) method allows you to connect your machine to a
wireless network by pressing both the (WPS) button on the control panel of your machine
and the (WPS) button on a Wi-Fi Protected Setup™ WPS-enabled access point (or
wireless router) respectively.
(WPS) button on the control panel for more than 2 seconds,
(WPS) button on the control panel for less than 2
- 220
­
(WPS)