Ikegami HC-HD300 Operation Manual page 110

5.2 Settings from the Menu
■ FILE SET
FILE SET creates a lens file.
To change the settings, select "LENS SELECT" on MENU (3/4), then "FILE SET".
The following explains the set values, descriptions, and setting procedures.
Set Value
OFF (default)
MANUAL
AUTO
Chart on which Kent paper, etc. has been pasted
and the entire surface is a uniform white.
Light
Note:
- The creation of lens file requires precise adjustment; therefore, lens files are protected against unintentional update by the S3-4 DIP
switch of the MPU module.
- When creating a lens file, set the optical filter to ND:100% and the ECC filter to 3200K. Also confirm that no special effect filter is
attached to the front of the lens or internal filter disk. If a special effect filter is attached, it may not be possible to correctly create the
lens file.
- When operating the DIP switch (S3) in the MPU module, turn the POWER switch of the camera OFF once.
1
Set the camera for level setup.
- Mount the standard lens, which is used as a reference lens, to the camera.
- Chart on which Kent paper, etc. has been pasted and the entire surface is uniform white.
- Use an illumination meter to adjust the light so that light is evenly distributed over the whole chart.
2
Dip switch S3-4 On allows creation of a lens file, Off prohibits creation of new lens files.
94
Does not create lens files.
Stores the current lens status as a file. ("LENS No. x" will be displayed at the bottom of the screen.)
Starts auto setup for lens file creation. ("PUSH SET -> START" will be displayed and flash at the bottom of
the screen.)
Light
Illumination
meter
Picture monitor
(connect if required)
HC-HD300 1412 VER1 (U)
Description
Camera
MON SDI OUT connector
Tripod
WFM
Coax cable